Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011WRANGLER RUBICON, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSVEHICLE THEFT SECURITY (SERVICE INFORMATION)SWITCH, HOOD AJARREMOVALSINGLE SWITCH
2011 Jeep Wrangler Rubicon, Standard
Single Switch
2011 Jeep Wrangler Rubicon, StandardSECTION Single Switch
Fig 1: Mounting Bracket, Two Remote Start Hood Ajar Switch Latch Tabs, Mounting Bracket & Harness Connector
- Open the hood.
- Disconnect and isolate the negative battery cable.
- Disconnect the IBS/negative battery cable assembly from the negative battery post.
- From the top of the mounting bracket (3) in the left front corner of the engine compartment, squeeze the two remote start hood ajar switch latch tabs (1) together and pull the switch upward.
- Pull the remote start hood ajar switch up through the hole in the mounting bracket (3) far enough to access and disconnect the harness connector (2) from the switch connector receptacle.
- Remove the remote start hood ajar switch from the engine compartment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.