Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011WRANGLER RUBICON, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSCABIN COMPARTMENT NODE (CCN) - ELECTRICAL DIAGNOSTICSDTC TROUBLESHOOTINGB2182-HEATED SEAT MODULE POWER SUPPLY HIGHDIAGNOSTIC TEST
2011 Jeep Wrangler Rubicon, Automatic
Diagnostic Test
2011 Jeep Wrangler Rubicon, AutomaticSECTION Diagnostic Test
- CHECK PCM FOR CHARGING SYSTEM DTC
- Turn the ignition on.
- With the scan tool, clear all DTC's.
- Cycle the ignition switch from on to off.
- Start the engine.
- Run the engine at approximately 1500 RPM for 1 minute.
- With the scan tool, read DTCs.
Are there any Charging System DTCs set in the PCM?
Yes
- Refer to CHARGING SYSTEM - DIAGNOSIS AND TESTING for Charging System diagnostic procedures.
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.