Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data - Totally Integrated Power Module (TIPM)
2011 Jeep Patriot 4WD L4-2.4LSECTION Scan Tool Data - Totally Integrated Power Module (TIPM)
SCAN TOOL DATA - TOTALLY INTEGRATED POWER MODULE (TIPM)
The following chart lists data values taken from the Scan Tool Totally Integrated Power Module (TIPM) data list. The data is to be used for reference only.
The following data values were recorded under the following conditions unless otherwise specified:
- Key On, Engine Off
- No DTCs set
- Engine at operating temperature
- Vehicle in Park or Neutral
- Doors Closed
- Accessories Off
- Altitude at 297.2 meters (975 ft.) above sea level
Not all of the scan tool data is applicable and may vary as much as 20 percent due to the following:
- Vehicle age and wear
- Altitude
- Weather
- Engine, Transmission and other Vehicle Options
- Aftermarket Accessories
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.