Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011LIBERTY RENEGADE, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 102 (POWER TRANSFER UNIT (SERVICE INFORMATION))SPECIFICATIONSSPECIFICATIONS
2011 Jeep Liberty Renegade, Part Time
Section 102 (Power Transfer Unit (Service Information)): Specifications: Specifications
2011 Jeep Liberty Renegade, Part TimeSECTION Specifications
WARNING: This page is about a different car, the 2011 Jeep Patriot and 2011 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Plug, Fill | 32 | 24 | - |
| Plug, Drain | 32 | 24 | - |
| Bolts, Inspection cover | 23 | 17 | - |
| Bolts, Vent Shield | 23 | 17 | - |
| Bolts, Vent | 23 | 17 | - |
| Bolts, Output Shaft Housing | 38 | 28 | - |
| Bolts, extension housing | 38 | 28 | - |
| Nut, Output Shaft | 150 | 111 | - |
| Bolts, Carrier Assembly Side Cover | 23 | 17 | - |
| Bolts, Ring Gear | 74 | 55 | - |
| Bolt and Nut, Rear Mount Through | 75 | 55 | - |
| Bolts, Transmission Crossmember | 75 | 55 | - |
| Bolt and Nut, Transmission Crossmember through | 75 | 55 | - |
| Bolts, PTU Mounting | 58 | 43 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.