Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011LIBERTY LIMITED, RWDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING SYSTEMPUMPINSTALLATION3.7L
2011 Jeep Liberty Limited, RWD
Steering System: Pump: Installation: 3.7L
2011 Jeep Liberty Limited, RWDSECTION 3.7L
| 1 - MOUNTING BOLTS |
| 2 - RESERVOIR |
| 3 - STEEL PULLEY |
- Install the pump to the vehicle.
- Install the three bolts (1) securing the pump to the engine. Tighten the bolts to 28 N.m (21 ft. Refer to Fig 1.lbs.).
- Install the power steering hoses. Tighten to 27 N.m (20 ft.lbs.).
- Install the serpentine belt. Refer to BELT, Serpentine, Installation .
- Refill the power steering fluid and check for leaks. Refer to Standard Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.