Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011LIBERTY 2WD V6-3.7LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHTESTING AND INSPECTION
2011 Jeep Liberty 2WD V6-3.7L
Cruise Control Switch: Testing and Inspection
2011 Jeep Liberty 2WD V6-3.7LSECTION Testing and Inspection
DIAGNOSIS AND TESTING
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
NOTE: The following test confirms only correct speed control switch functions. It does not test or confirm any of the Local Interface Network (LIN) slave node inputs, outputs or functions. LIN slave node testing requires the use of a diagnostic scan tool. Refer to the appropriate diagnostic information.
1. Remove the speed control switch pod from the steering wheel. Speed Control Switch - Removal.
2. Disconnect the steering wheel wire harness connector from the back of the speed control switch pod.
3. Using an ohmmeter, test the resistance between the terminals of the switch as shown in the Speed Control Switch Tests table.
4. If the switch fails any of the tests, replace the ineffective speed control switch pod as required.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.