Programming and Relearning

MEMORY SYSTEM PROGRAMMING

NOTE: The Memory Seat Module (MSM) will abort a recall if the transmission is moved out of Park position, or if any seat movement is activated manually or by memory recall. The MSM will also abort a recall if any movement of the adjustable pedals is detected.

MEMORY SYSTEM PROGRAMMING

The Memory Seat Module (MSM) interfaces with the Remote Keyless Entry (RKE) system/ WIN over the Controller Area Network (CAN) bus. The proper procedure of setting and recalling a memory position using the RKE is as follows:

1. Press and release memory switch 1 or 2 to recall memory position 1 or 2.
2. Adjust the seat, recliner, adjustable pedal position, set radio station presets, set HVAC temperature preset, and the side view mirrors to the desired position.
3. Press momentarily and release memory switch S.
4. Within five seconds, press momentarily and release memory switch 1 or 2.
5. To link the FOBIK transmitter, the FOBIK must be removed from the ignition swith: within ten seconds, press and release the "LOCK" button on one of the RKE transmitters

To program the second driver's position, repeat the above procedure using memory switch 2. The second RKE transmitter can be programmed in the same fashion as indicated in 5.

To recall either of the programmed positions momentarily press and release either memory selector switch 1 or 2. If using FOBIK, just press and release the "UNLOCK" button on the proper transmitter for either position 1 or 2.

A recall is possible any time the vehicle transmission is in PARK and the seatbelt is unbuckled. This condition is monitored by the MSM.

TO DISABLE A RKE TRANSMITTER LINKED TO MEMORY

1. Turn the ignition switch to the OFF position and remove the key.
2. Press and release the memory SET button located on the driver's seat.
3. Within 10 seconds, press and release the UNLOCK button on the RKE transmitter.To disable another RKE transmitter linked to either memory position, repeat Steps 1-3 for each RKE transmitter.

NOTE: The capability to link RKE transmitters to memory is enabled when delivered from the factory. The capability to link RKE transmitters to memory can be disabled (or later re-enabled) by an authorized dealer. For vehicles equipped with the Electronics Vehicle Information Center (EVIC) under setup features.