Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011GRAND CHEROKEE 2WD V8-5.7LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING GEARSERVICE AND REPAIRSTEERING GEAR - INSTALLATION
2011 Jeep Grand Cherokee 2WD V8-5.7L
Steering Gear - Installation
2011 Jeep Grand Cherokee 2WD V8-5.7LSECTION Steering Gear - Installation
5.7L
CAUTION: The Steering Column Control Module (SCCM) is centered to the vehicles steering system. Failure to keep the system and steering column module centered and locked/inhibited from rotating can result in SCCM damage.
1. Position the steering gear (3) between the RH upper and lower parts of the cradle (crossmember) (1) as far as necessary to lower the LH side of the steering gear (3) into position and shift to the left.
2. Install the steering gear retaining bolts/nuts (2) and tighten to 244 Nm (180 ft. lbs.).
3. Install the engine cradle (1) Engine and Suspension Cradle.
4. If the outer tie rods were removed, install the tie rod ends Tie Rod End - Installation.
5. Perform a front alignment Service and Repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.