Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011GRAND CHEROKEE 2WD V6-3.6LREPAIR AND DIAGNOSISMAINTENANCETUNE-UP AND ENGINE PERFORMANCE CHECKSAIR CLEANER HOUSINGSERVICE AND REPAIRAIR CLEANER BODY - INSTALLATION
2011 Jeep Grand Cherokee 2WD V6-3.6L
Air Cleaner Body - Installation
2011 Jeep Grand Cherokee 2WD V6-3.6LSECTION Air Cleaner Body - Installation
INSTALLATION
1. Install the air cleaner body (1) straight down on the locating pins while routing the air inlet under the hood seal (2).
2. Install the push pin (3).
3. Engage the hose retainer (5) to the air cleaner body.
4. Install the fresh air makeup hose (4) to the air cleaner body.
5. Install the resonator (3) to the air cleaner body and the throttle body. Tighten the clamps (1) and (4) to 4 Nm (35 in. lbs.).
6. Connect the electrical connector (2) to the Inlet Air Temperature (IAT) sensor.
7. Install the engine cover (1).
8. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.