Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSJEEP2011GRAND CHEROKEE 2WD V6-3.6LREPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSMEMORY POSITIONING MODULEDESCRIPTION AND OPERATIONMEMORY SEAT MODULE - DESCRIPTION
2011 Jeep Grand Cherokee 2WD V6-3.6L
Memory Seat Module - Description
2011 Jeep Grand Cherokee 2WD V6-3.6LSECTION Memory Seat Module - Description
DESCRIPTION
When equipped, the Memory Seat Module (MSM) (1) is located underneath the driver seat. It is used in conjunction with the other modules in the memory system to recall the driver seat to two different driver preset seat position preferences. The memory seat module is able to store and recall all driver side power seat positions (fore/aft, up/down, tilt and recline), outside mirror position, power steering column position and up to twelve radio station presets (six AM and six FM), on vehicles with a factory installed radio connected to the Controller Area Network (CAN) data bus network. The memory system will also store and recall the last radio station listened to for each driver, even if it is not one of the twelve preset stations.
The memory seat system will automatically recall the settings when a button of the memory switch located in the driver door trim panel is pressed, or when the doors are unlocked using the Remote Keyless Entry (RKE) transmitter (if the "RKE Linked to Memory" feature is enabled). If the vehicle has more than two drivers the RKE transmitter recall of memory features can be disabled. This is a customer programmable feature.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.