Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011GRAND CHEROKEE 2WD V6-3.6LREPAIR AND DIAGNOSISBODY AND FRAMEEXTERIOR MOULDING / TRIMSERVICE AND REPAIRBODY SIDE MOLDING - INSTALLATION
2011 Jeep Grand Cherokee 2WD V6-3.6L
Body Side Molding - Installation
2011 Jeep Grand Cherokee 2WD V6-3.6LSECTION Body Side Molding - Installation
INSTALLATION
1. Clean body surface with MOPAR(R) Super Kleen solvent or equivalent. Wipe surface dry with lint free cloth.
2. Remove protective cover from tape on back of molding. Apply molding to body below the masking tape guide.
3. Remove masking tape guide and firmly press molding to body surface to assure adhesion.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.