SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LIMITED, FWD, AUTOMATIC CVTREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESTOTALLY INTEGRATED POWER MODULE (TIPM) - DTCS B106B TO B2304DIAGNOSIS AND TESTINGB1633-LEFT HI BEAM CONTROL CIRCUIT LOWDIAGNOSTIC TEST
2011 Jeep Compass Limited, FWD, Automatic CVT

Diagnostic Test

2011 Jeep Compass Limited, FWD, Automatic CVTSECTION Diagnostic Test
  1. INTERMITTENT CONDITION 
    1. Turn the ignition on.
    2. With the scan tool, clear all TIPM DTCs.
    3. Turn the Highbeam Headlamps on.
    4. With the scan tool read the DTC information.

      Does the scan tool read: B1633-LEFT HI BEAM CONTROL CIRCUIT LOW?

      Yes 

      • Go To  2.

      No 

      • The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
      • Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
  2. (L33) LEFT HIGHBEAM OUTPUT CIRCUIT 
    Fig 1: Measuring Resistance Between Ground & Left High Beam Output Circuit
    GC0100126Courtesy of CHRYSLER LLC
    1. Turn the ignition off.
    2. Disconnect the TIPM C5 harness connector.
    3. Disconnect the Left Headlamp harness connector.
    4. Measure the resistance between ground and the Left Highbeam Output circuit.

      Is the resistance below 5.0 Ohms?

      Yes 

      • Repair the (L33) Left Highbeam Output circuit for a short to ground condition.
      • Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .

      No 

      • Replace the Totally Integrated Power Module (TIPM) in accordance with the service information.
      • Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.