SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LIMITED, AWD, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSENGINE COOLING SYSTEMENGINEPUMP, WATERREMOVALDIESEL
2011 Jeep Compass Limited, AWD, Standard

PUMP, Water: Removal: Diesel

2011 Jeep Compass Limited, AWD, StandardSECTION Diesel
Fig 1: Power Steering Pressure Line Retaining Bracket Bolt
GC0137795Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Drain the power steering fluid.
  3. Raise and support the vehicle.
    NOTE:

    Drain the fluid in a clean container, free of debris. Save the fluid for re-use.

  4. Drain the cooling system. Refer to Standard Procedure .
  5. Remove the accessory drive belt (1). Refer to BELT, Serpentine, Removal .
  6. Loosen the band clamps (4) and disconnect the coolant return hose from the water pump (3).
  7. Remove the power steering line retaining bracket bolt (2).
    Fig 2: Vacuum Lines, Coolant Inlet Hose, Power Steering Pump Supply Hose & Vacuum Switch Connector
    GC0137796Courtesy of CHRYSLER LLC
  8. Remove the coolant inlet hose (2) at the pump.
  9. Remove the thermostat bypass hose at the pump.
  10. Remove the power steering pump supply hose (1) at the pump.
  11. Remove the power steering vacuum lines (3).
  12. Disconnect the electronically controlled vacuum switch connector (4).
    Fig 3: Identifying Water/Power Steering Pump Assembly
    GC0137797Courtesy of CHRYSLER LLC
  13. Remove the power steering pressure line (2).
  14. Remove the water/power steering pump support bracket bolt.
  15. Remove the water/power steering pump mounting bolts (1).
  16. Remove the water/power steering pump (3).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.