Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LIMITED, AWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION) - MK)MODULE, TRANSMISSION CONTROL (TCM)OPERATIONINPUTS AND OUTPUTS
2011 Jeep Compass Limited, AWD, Standard
Inputs And Outputs
2011 Jeep Compass Limited, AWD, StandardSECTION Inputs And Outputs
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Shift Control | Line Pressure Control | Selection Control | Lock-up Control | CAN Communication Control | Fail-safe Function (Note 1) | |
|---|---|---|---|---|---|---|---|
| Input | Engine speed signal | X | X | X | X | X | |
| Accelerator pedal position signal | X | X | X | X | X | X | |
| Closed throttle position signal | X | X | X | ||||
| Stop lamp SW signal | X | X | X | X | X | ||
| Primary pressure sensor | X | ||||||
| Secondary pressure sensor | X | X | X | ||||
| Fluid temperature sensor | X | X | X | X | X | ||
| Primary speed sensor | X | X | X | X | |||
| Secondary speed sensor | X | X | x | X | X | ||
| PNP switch | X | X | X | X | X | ||
| Output | Line pressure solenoid value | X | x | X | |||
| Secondary pressure solenoid value | X | X | X | ||||
| Lock-up solenoid value | X | X | X | ||||
| Lock-up/Selection switching solenoid value | X | X | X | ||||
| Stepping motor | X | X |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.