Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LIMITED, AWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION) - MK)MODULE, TRANSMISSION CONTROL (TCM)INSTALLATION
2011 Jeep Compass Limited, AWD, Standard
Module, Transmission Control (TCM): Installation
2011 Jeep Compass Limited, AWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Install the TCM mounting bracket holes (1) over the two studs on the bulkhead.
- Install the two nuts (4) to mounting studs (1) on the bulkhead.
- Position the body harness aside to gain access to the mounting studs.
- Tighten nuts (4) to 15 N.m (133 in. lbs.).
- Plug in electrical connectors (2) to TCM (3).
- If a new TCM is installed a learn procedure must be performed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.