Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LIMITED, AWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION) - MK)MODULE, COMPASSINSTALLATION
2011 Jeep Compass Limited, AWD, Standard
Module, Compass: Installation
2011 Jeep Compass Limited, AWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Remote Compass Module (RCM) must be calibrated after installation.
- Position the RCM (1) on top of the instrument panel (2).
- Install the screws (3) that secure the RCM to the instrument panel.
- Connect the electrical connector (4).
- Install the instrument panel top cover. Refer to COVER, INSTRUMENT PANEL, INSTALLATION .
- Reconnect the negative battery cable.
- Calibrate the compass module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.