Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LIMITED, AWD, AUTOMATIC CVT, CVT3REPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEM (SERVICE INFORMATION)SOLENOID, VARIABLE VALVE TIMINGINSTALLATIONFRONT SOLENOID 1/1
2011 Jeep Compass Limited, AWD, Automatic CVT, CVT3
Front Solenoid 1/1
2011 Jeep Compass Limited, AWD, Automatic CVT, CVT3SECTION Front Solenoid 1/1
- Solenoid for front location 1/1. Note mounting tab location is different between front and rear solenoids.
- Install solenoid into cylinder head.
- Install mounting bolt and tighten to 12 N.m (9 ft. lbs.).
- Install oil pressure sensor.
- Connect electrical connector to oil pressure sensor.
- Connect electrical connector to Variable valve timing solenoid.
- Connect negative battery cable.
- Install engine cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.