Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LATITUDE, 2.4 B, AWD, AUTOMATIC CVT, CVT3REPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING SYSTEMPUMPDIAGNOSIS AND TESTINGDIAGNOSIS AND TESTING - POWER STEERING PUMP AND HOSESCHECKING FOR POWER STEERING HOSES TOUCHING BODY OR FRAME OF VEHICLE
2011 Jeep Compass Latitude, 2.4 B, AWD, Automatic CVT, CVT3
Checking For Power Steering Hoses Touching Body Or Frame Of Vehicle
2011 Jeep Compass Latitude, 2.4 B, AWD, Automatic CVT, CVT3SECTION Checking For Power Steering Hoses Touching Body Or Frame Of Vehicle
Check hoses and hose tubes as following:
- Inspect hoses and hose tubes for witness marks. If witness marks are present, adjust hose(s) to the proper position by loosening, repositioning and tightening attachments to the specified torque. Refer to Specifications . Do not bend tubing to adjust. Replace the hose assembly if damaged.
- Check fastener torque of hose mounting brackets and tube nuts. Refer to Specifications .
- Have a helper bump the steering gear off of the stops to induce pressure fluctuations which may move the hose. If hose contact is made, adjust hose(s) to the proper position by loosening, repositioning and tightening attachments to the specified torque. Refer to Specifications . Do not bend tubing to adjust. Replace the hose assembly if damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.