Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LATITUDE, 2.4 B, AWD, AUTOMATIC CVT, CVT3REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER DOORS - NON-DTC BASED DIAGNOSTICSDIAGNOSIS AND TESTINGDRIVER DOOR FAILS TO UNLOCKDIAGNOSTIC TEST
2011 Jeep Compass Latitude, 2.4 B, AWD, Automatic CVT, CVT3
Diagnostic Test
2011 Jeep Compass Latitude, 2.4 B, AWD, Automatic CVT, CVT3SECTION Diagnostic Test
- (P238) DRIVER DOOR UNLOCK DRIVER WIRE SHORT TO GROUND
- Turn the ignition off.
- Disconnect the Instrument Cluster C1 connector.
- Measure the resistance between ground and the (P238) Driver Door Unlock Driver circuit.
Is the resistance below 1, 000 ohms?
Yes
- Repair the (P238) Driver Door Unlock Driver wire for a short to ground.
- Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
No
- Replace the Instrument Cluster in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.