Section 4 (Rear Driveline Module): Specifications: Specifications

2011 Jeep Compass Base, 2.4 B, FWD, Automatic CVTSECTION Specifications
WARNING: This page is about a different variant/trim than selected.
DESCRIPTION N.m Ft. Lbs. In. Lbs.
Bolt, Harness Bracket 10 - 89
Bolts, Driveline Module Side Mounting 102 75 -
Bolt, Rear Driveline Module 102 75 -
Bolts, Stay Bracket 61 45 -
Nut, Sway Bar 61 45 -
Nut, Pinion 74 54 -
Bolts, Ring Gear 41 30 -
Bolts, Carrier Cap 48 35 -
Bolts, Differential Cover 23 16 -
Bolts, ECC to RDA 78 58 -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.