Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS BASE, 2.4 B, AWD, AUTOMATIC CVT, CVT3REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSCABIN COMPARTMENT NODE (CCN) - ELECTRICAL DIAGNOSTICSDTC TROUBLESHOOTINGU113B-LOST COMMUNICATION WITH SWITCH BANK MODULEDIAGNOSTIC TEST
2011 Jeep Compass Base, 2.4 B, AWD, Automatic CVT, CVT3
Diagnostic Test
2011 Jeep Compass Base, 2.4 B, AWD, Automatic CVT, CVT3SECTION Diagnostic Test
- CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, read DTCs.
Does the scan tool display: U113B-LOST COMMUNICATION WITH SWITCH BANK MODULE?
Yes
- Go To 2.
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- (D506) LIN BUS CIRCUIT OPEN
- Turn the ignition off.
- Disconnect the Switch Bank harness connector.
- Turn the ignition on.
- Measure the voltage of the (D506) LIN BUS circuit.
Is the voltage above 5.0 volts?
Yes
- Go To 3.
No
- Repair the (D506) LIN BUS circuit for an open.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .
- (A935) FUSED B+ CIRCUIT OPEN
- Measure the voltage of the (A935) Fused B+ circuit.
Is the voltage above 10.0 volts?
Yes
- Go To 4.
No
- Repair the (A935) Fused B+ circuit for an open.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .
- Measure the voltage of the (A935) Fused B+ circuit.
- (Z908) GROUND CIRCUIT OPEN
- Measure the resistance between ground and the (Z908) Ground circuit.
Is the resistance below 10K Ohms?
Yes
- Replace the Switch Bank in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .
No
- Repair the (Z908) Ground circuit for an open.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .
- Measure the resistance between ground and the (Z908) Ground circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.