Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2010LIBERTY 2WD V6-3.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR TEMPERATURE SENSOR ( AMBIENT / INTAKE )SERVICE AND REPAIRREMOVAL
2010 Jeep Liberty 2WD V6-3.7L
Removal
2010 Jeep Liberty 2WD V6-3.7LSECTION Removal
REMOVAL
The intake manifold air temperature (IAT) sensor (1) is installed into the rubber air intake tube near the throttle body.
1. Disconnect electrical connector (2) from IAT sensor.
2. Clean dirt from IAT sensor base.
3. Pull out on IAT sensor (1) while rotating for removal.
4. Check condition of sensor O-ring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.