Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2010COMPASS LIMITED, EDG, AUTOMATIC CVTREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - GAS - CHECKING FOR AN INTERMITTENT DTC, PCM/TCM PROGRAMMING, PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE & PCM VERIFICATION TEST
2010 Jeep Compass Limited, EDG, Automatic CVT
Engine Controls - Gas - Checking For An Intermittent DTC, Pcm/TCM Programming, Pre-Diagnostic Troubleshooting Procedure & Pcm Verification Test
2010 Jeep Compass Limited, EDG, Automatic CVTSECTION Engine Controls - Gas - Checking For An Intermittent DTC, Pcm/TCM Programming, Pre-Diagnostic Troubleshooting Procedure & Pcm Verification Test
- Standard Procedure
- Checking For An Intermittent DTC
- Pcm/TCM Programming
- Pcm/TCM Flash PROGRAMING
- Table of Contents
- Section 1 - Pcm/TCM Flash Procedure
- REPAIR PROCEDURE - Using StarSCAN® or StarMOBILE® Desktop Client
- REPAIR PROCEDURE - wiTECH™ Diagnostic Application
- Section 2 - Additional Pcm/TCM Replacement Procedures
- Step-By-Step Instructions
- Section 3 - Authorized Modification Label
- Required Tools/Equipment:
- TECH TIPS and INFORMATION:
- Parts Required
- Pre-Diagnostic Troubleshooting Procedure
- Pcm Verification Test
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.