Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2010COMPASS LIMITED, EDG, AUTOMATIC CVTREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMGAS - DTCS P0703 TO P2016P1602-PCM NOT PROGRAMMEDDIAGNOSTIC TEST
2010 Jeep Compass Limited, EDG, Automatic CVT
Diagnostic Test
2010 Jeep Compass Limited, EDG, Automatic CVTSECTION Diagnostic Test
- PCM NOT PROGRAMMED
- Ignition on, engine not running.
- Program the PCM in accordance with the Service Information.
- Start the engine.
- Allow the engine to reach normal operating temperature.
- With a scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
- Replace and program the Powertrain Control Module per Service Information.
- Perform the PCM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
No
- The PCM has been successfully programmed. Test is complete.
- Perform the PCM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.