SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2010COMPASS LIMITED, EDG, AUTOMATIC CVTREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMGAS - DTCS P0703 TO P2016P1593-SPEED CONTROL SWITCH 1/2 STUCKDIAGNOSTIC TEST
2010 Jeep Compass Limited, EDG, Automatic CVT

Diagnostic Test

2010 Jeep Compass Limited, EDG, Automatic CVTSECTION Diagnostic Test
  1. DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE 
    NOTE: Refer to the following table when diagnosing speed control switch voltage DTCs.
    - Switch 1 voltage  Switch 2 voltage 
    On/Off - Min. 0.5882 3.5294
    On/Off - Max. 1.1373 3.9216
    Set - Min. 3.1569 1.1765
    Set - Max. 3.5686 1.5686
    Cancel - Min. 1.5882 2.8431
    Cancel - Max. 2.0000 3.2549
    Accel - Min. 3.8824 2.0392
    Accel - Max. 4.1765 2.4706
    1. Start the engine and allow it to idle for at least 60 seconds.
      WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing. Failure to follow these instructions may result in possible serious or fatal injury.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.