Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2010COMPASS LIMITED, EDG, AUTOMATIC CVTREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMGAS - DTCS P0503 TO P060F
2010 Jeep Compass Limited, EDG, Automatic CVT
Gas - DTCS P0503 To P060F
2010 Jeep Compass Limited, EDG, Automatic CVTSECTION Gas - DTCS P0503 To P060F
- P0503-Vehicle Speed Sensor 1 Erratic (MTX Non-Abs)
- P0506-Idle Speed Performance Lower Than Expected
- P0507-Idle Speed Performance Higher Than Expected
- P050B-Cold Start Ignition Timing Performance
- P0513-Invalid Skim Key
- P0522-Engine Oil Pressure Switch Circuit Low
- P0523-Engine Oil Pressure Switch Circuit High
- P0532-A/C Pressure Sensor Circuit Low
- P0533-A/C Pressure Sensor Circuit High
- P0562-Battery Voltage Low
- P0563-Battery Voltage High
- P0571-Brake Switch 1 Performance
- P0572-Brake Switch 1 Stuck On
- P0573-Brake Switch 1 Stuck Off
- P0579-Speed Control Switch 1 Performance
- P0580-Speed Control Switch 1 Circuit Low
- P0581-Speed Control Switch 1 Circuit High
- P0585-Speed Control Switch 1/2 Correlation
- P0591-Speed Control Switch 2 Performance
- P0592-Speed Control Switch 2 Circuit Low
- P0593-Speed Control Switch 2 Circuit High
- P0600-Serial Communication Link
- P060B-Etc A/D Ground Performance
- P060D-Etc Level 2 App Performance
- P060E-Etc Level 2 TPS Performance
- P060F-Etc Level 2 ECT Performance
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.