Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009WRANGLER UNLIMITED X, 4WD, AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONDTC INDEXINTRUSION TRANSCEIVER MODULE (ITM) - ELECTRICAL DIAGNOSTICS
2009 Jeep Wrangler Unlimited X, 4WD, Automatic
Intrusion Transceiver Module (ITM) - Electrical Diagnostics
2009 Jeep Wrangler Unlimited X, 4WD, AutomaticSECTION Intrusion Transceiver Module (ITM) - Electrical Diagnostics
| DTC | Description |
|---|---|
| B1A20 | PRE-ARM TIMEOUT |
| B1A3C | INTERNAL SIREN BATTERY |
| B1A3D | SIREN BATTERY TAMPER/LOSS OF POWER SUPPLY |
| B1A3E | SIREN/ITM MISMATCH |
| B1A3F | ITM ARMING SEQUENCE PERFORMANCE |
| B1A48 | INTRUSION SENSOR 1 INTERNAL |
| B1A5F | INTRUSION SENSOR 2 INTERNAL |
| B1A6D | INTRUSION SENSOR 3 INTERNAL |
| B2206 | CURRENT VIN MISSING/MISMATCH |
| B223B | VEHICLE CONFIGURATION MISMATCH |
| B223C | INTRUSION TRANSCEIVER MODULE INTERNAL |
| U0100 | LOST COMMUNICATION WITH ECM/PCM |
| U0155 | LOST COMMUNICATION WITH CLUSTER/CCN |
| U1008 | LIN 1 BUS |
| U110D | LOST COMMUNICATION WITH SECURITY SIREN |
| U1169 | LOST COMMUNICATION WITH INTRUSION SENSOR 1 |
| U1170 | LOST COMMUNICATION WITH INTRUSION SENSOR 2 |
| U1179 | LOST COMMUNICATION WITH INTRUSION SENSOR 3 |
| U1416 | IMPLAUSIBLE SECURITY SIREN SIGNAL RECEIVED |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.