SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009WRANGLER SAHARA, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCONNECTOR END VIEWSCONNECTOR PIN-OUTSPOWERTRAIN CONTROL MODULE (GAS) CONNECTOR END VIEW (C2)
2009 Jeep Wrangler Sahara, Standard

Powertrain Control Module (Gas) Connector End View (C2)

2009 Jeep Wrangler Sahara, StandardSECTION Powertrain Control Module (Gas) Connector End View (C2)
MODULE-POWERTRAIN CONTROL C2 - BLACK/ORANGE 38 WAY (GAS)

GJK880176Courtesy of CHRYSLER CORP.
CAV  CIRCUIT  FUNCTION 
1 - -
2 - -
3 - -
4 K58 16BR/VT INJECTOR 6 CONTROL
5 K38 16BR/RD INJECTOR 5 CONTROL
6 K124 18TN/YL ETC MOTOR (+)
7 K18 16DB/OR COIL 3 CONTROL
8 K35 18DB/VT EGR CONTROL
9 K17 16DB/TN COIL 2 CONTROL
10 K19 16DB/DG COIL 1 CONTROL
11 K14 16BR/TN INJECTOR 4 CONTROL
12 K13 16BR/LB INJECTOR 3 CONTROL
13 K12 16BR/DB INJECTOR 2 CONTROL
14 K11 16BR/YL INJECTOR 1 CONTROL
15 K922 18BR/PK TP SENSOR GROUND
16 - -
17 K199 18BR/VT O2 2/1 HEATER CONTROL
18 K99 18BR/LG O2 1/1 HEATER CONTROL
19 K125 18BR/GY GEN FIELD CONTROL
20 K2 18VT/OR ECT SIGNAL
21 K22 18BR/OR TP SIGNAL 1
22 K34 18DB/LG EGR SIGNAL
23 K1 18VT/BR MAP SIGNAL
24 K942 18BR/LG KS RETURN
25 K42 18DB/YL KS SIGNAL
26 - -
27 K900 18DB/DG SENSOR GROUND
28 K122 18BR/DG TP SIGNAL 2
29 F855 18PK/YL 5 VOLT SUPPLY
30 K21 18DB/LG IAT SIGNAL
31 K41 18DB/LB O2 1/1 SIGNAL
32 K902 18BR/DG O2 RETURN (UP)
33 K43 18DB/LG O2 2/1 SIGNAL
34 K44 18DB/GY CMP SIGNAL
35 K24 18BR/LB CKP SIGNAL
36 - -
37 - -
38 K126 18TN/OR ETC MOTOR (-)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.