Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009WRANGLER RUBICON, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 ((TRANSMISSION CONTROL MODULE (TCM) - ELECTRICAL DIAGNOSTICS))DTC TROUBLESHOOTINGP0602-CONTROL MODULE PROGRAMMING ERROR/NOT PROGRAMMEDDIAGNOSTIC TEST
2009 Jeep Wrangler Rubicon, Standard
Diagnostic Test
2009 Jeep Wrangler Rubicon, StandardSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CONTROL MODULE PROGRAMMING ERROR NOTE: Controller is programmed with generic software and will not allow the correct vehicle Powertrain management.
- With the scan tool.
- Record the vehicles controller part number.
- Select Use Controller Part Number under the Flash Tab.
- Flash the controller with the correct software.
Verify the controller flashed successfully.
Test Complete
- Perform the 545RFE TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.