Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2009WRANGLER RUBICON, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTS(CABIN COMPARTMENT NODE (CCN) - ELECTRICAL DIAGNOSTICS)DTC TROUBLESHOOTINGB161A-COURTESY/DOME LAMP CONTROL CIRCUITDIAGNOSTIC TEST

2009 Jeep Wrangler Rubicon, Standard

Diagnostic Test

2009 Jeep Wrangler Rubicon, StandardSECTION Diagnostic Test

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. Turn the Courtesy Lamps on.
3. With the scan tool, read DTCs.
  Does the scan display this DTC as active?
  
  Yes
  - Go to step 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
CHECK THE (M24) COURTESY LAMPS DRIVER CIRCUIT FOR A SHORT TO GROUND

Fig 1: Checking Courtesy Lamps Driver Circuit For Short To Ground
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Dome Lamp.
3. Disconnect the Cargo Lamp (4 door).
4. Disconnect the Cluster C2 harness connector.
5. Measure the resistance between ground and the (M24) Courtesy Lamp Driver circuit.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Repair the (M24) Courtesy Lamp Driver circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Go to step 3
CHECK THE (M24) COURTESY LAMPS DRIVER CIRCUIT FOR AN OPEN

Fig 2: Checking Courtesy Lamps Driver Circuit For Open
Courtesy of CHRYSLER LLC
1. Measure the resistance of the (M24) Courtesy Lamp Driver circuit.
  Is the resistance above 5 Ohms?
  
  Yes
  - Repair the (M24) Courtesy Lamp Driver circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure
  No
  - Replace the Cluster in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.