Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Possible Causes
2009 Jeep Wrangler Rubicon, AutomaticSECTION Possible Causes
| Possible Causes |
|---|
| TRS SENSE CIRCUIT OPEN |
| TRS SENSE CIRCUIT SHORTED TO GROUND |
| TRS SENSE CIRCUIT SHORTED TO VOLTAGE |
| METAL DEBRIS IN OIL PAN |
| TRANSMISSION RANGE SENSOR (TRS) |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting Procedure before proceeding. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
SHIFT LEVER ERROR CODES
| ERROR CODE | SWITCH STUCK | POSITION |
|---|---|---|
| 1 | T41 (C1) | OPEN |
| 2 | T41 (C1) | CLOSED |
| 3 | T42 (C2) | OPEN |
| 4 | T42 (C2) | CLOSED |
| 5 | T3 (C3) | OPEN |
| 6 | T3 (C3) | CLOSED |
| 7 | T1 (C4) | OPEN |
| 8 | T1 (C4) | CLOSED |
| 9 | T2 (C5) | OPEN |
| 10 | T2 (C5) | CLOSED |
| 11 | OD LOCKOUT | OPEN |
| 12 | OD LOCKOUT | CLOSED |
TRS SWITCH STATES
| - | PARK | TMP 1 | REV | TMP 2 | N1 | N2 | TMP 3 | D | TMP 4 | 2 | TMP 5 | L |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| T41 (C1) | CL | OP | OP | OP | CL | CL | OP | OP | OP | OP | OP | OP |
| T42 (C2) | CL | CL | CL | CL | CL | CL | CL | OP | OP | OP | OP | OP |
| T3 (C3) | OP | OP | OP | CL | CL | CL | CL | CL | OP | OP | OP | CL |
| T1 (C4) | OP | OP | OP | OP | OP | CL | CL | CL | CL | CL | OP | OP |
| T2 (C5) | CL | CL | OP | OP | OP | OP | OP | OP | OP | CL | CL | CL |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.