Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009WRANGLER 2WD V6-3.8LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYPISTON RING, ENGINE
2009 Jeep Wrangler 2WD V6-3.8L
Piston Ring, Engine
2009 Jeep Wrangler 2WD V6-3.8LSECTION Piston Ring, Engine
PISTON RINGS
Ring End Gap
Top Compression Ring 0.20-0.36 mm (0.008-0.014 in.)
Second Compression Ring 0.30-0.55 mm (0.012-0.022 in.)
Oil Control (Steel Rails) 0.25-0.76 mm (0.010-0.030 in.)
Wear Limit-Compression Rings 0.75 mm (0.030 in.)
Wear Limit-Oil Control Steel Rails 1.88 mm (0.074 in.)
Ring Side Clearance
Top Compression Ring 3.8L 0.030-0.069 mm (0.0012-0.0027 in.)
Second Compression Ring 3.8L 0.041-0.085 mm (0.0016-0.0033 in.)
Oil Ring (Steel Ring) 0.015-0.225 mm (0.0006-0.0089 in.)
Side Clearance Wear Limit- Top Ring 0.10 mm (0.004 in.)
Side Clearance Wear Limit-2nd Ring 0.13 mm (0.005 in.)
Radial Wall Wear Limit Oil Ring Pack 0.038 mm (0.0015 in.)
Ring End Gap
Top Compression Ring 0.20-0.36 mm (0.008-0.014 in.)
Second Compression Ring 0.30-0.55 mm (0.012-0.022 in.)
Oil Control (Steel Rails) 0.25-0.76 mm (0.010-0.030 in.)
Wear Limit-Compression Rings 0.75 mm (0.030 in.)
Wear Limit-Oil Control Steel Rails 1.88 mm (0.074 in.)
Ring Side Clearance
Top Compression Ring 3.8L 0.030-0.069 mm (0.0012-0.0027 in.)
Second Compression Ring 3.8L 0.041-0.085 mm (0.0016-0.0033 in.)
Oil Ring (Steel Ring) 0.015-0.225 mm (0.0006-0.0089 in.)
Side Clearance Wear Limit- Top Ring 0.10 mm (0.004 in.)
Side Clearance Wear Limit-2nd Ring 0.13 mm (0.005 in.)
Radial Wall Wear Limit Oil Ring Pack 0.038 mm (0.0015 in.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.