Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009PATRIOT LIMITED, EDG, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, TRANSMISSION CONTROLSTANDARD PROCEDURETRANSMISSION CONTROL MODULE INITIALIZATIONRELEARN, AFTER REPLACING A TRANSAXLE
2009 Jeep Patriot Limited, EDG, Standard
Relearn, After Replacing A Transaxle
2009 Jeep Patriot Limited, EDG, StandardSECTION Relearn, After Replacing A Transaxle
- Turn ignition key to RUN.
- Clear learning memory using the scan tool.
- Turn the ignition key to OFF/LOCKED for 2 seconds.
- Turn the ignition key to RUN Clear DTCs.
- Turn the ignition key to OFF/LOCKED for 2 seconds.
- Turn ignition key to RUN.
- After at least 7 seconds, read DTCs.
- If DTCs resets. Refer to Transmission and Transfer Case/Automatic - CVT - Diagnosis and Testing .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.