SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009PATRIOT 2WD L4-2.4LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORSERVICE AND REPAIRFUEL PUMP MODULE - INSTALLATION
2009 Jeep Patriot 2WD L4-2.4L

Fuel Pump Module - Installation

2009 Jeep Patriot 2WD L4-2.4LSECTION Fuel Pump Module - Installation





FWD

NOTE: The pump has to be properly located to the tank for the fuel gauge to work properly.





1. Wipe seal area of tank clean. Place a new seal between the tank threads and the pump module opening.





2. Install module.





3. Position fuel pump module in tank. Make sure the alignment tab lines up on the fuel tank and pump module for Gas or Diesel fuel tanks.





4. While holding the pump module in position, install lock ring and use special tool Spanner Wrench #9340 to tighten lock ring.





5. Install plastic cover.





6. Install rear cushion.





7. Install the negative battery cable.
8. Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
9. Fill fuel tank with clean fuel. Use the Scan Tool to pressurize the system and check for leaks.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.