Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009LIBERTY LIMITED, 4WD, PART TIMEREPAIR AND DIAGNOSISTRANSMISSIONTRANSFER CASEFINAL DRIVE CONTROL MODULE (FDCM) - ELECTRICAL DIAGNOSTICSDTC TROUBLESHOOTINGC1406-TRANSFER CASE BRAKE PERFORMANCESET CONDITIONS
2009 Jeep Liberty Limited, 4WD, Part Time
Set Conditions
2009 Jeep Liberty Limited, 4WD, Part TimeSECTION Set Conditions
- Set Condition:
1. The Final Drive Control Module (FDCM) detects an excessive voltage variation on the Mode Sensor Signal circuit.
2. The Final Drive Control Module (FDCM) performs an error correction procedure too frequently.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.