Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009LIBERTY 2WD V6-3.7LREPAIR AND DIAGNOSISBODY AND FRAMEDOORS, HOOD AND TRUNKHOODSERVICE AND REPAIRHOOD - INSTALLATION
2009 Jeep Liberty 2WD V6-3.7L
Hood - Installation
2009 Jeep Liberty 2WD V6-3.7LSECTION Hood - Installation
INSTALLATION
1. With the aid of a helper, the position hood (1) onto the hinges (4).
2. Install nuts (3) finger-tight.
3. Align hinges with installation reference marks made previously and tighten bolts to 20 Nm (15 ft. lbs.).
4. Inspect hood for proper alignment and adjust as necessary, Adjustments.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.