Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009GRAND CHEROKEE LIMITED, 4.7 P, 4WDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSTRANSMISSION CONTROL MODULE (TCM) - ELECTRICAL DIAGNOSTICSDTC TROUBLESHOOTINGP1704-INPUT SPEED SENSOR 1 OVERSPEEDMONITOR CONDITIONS
2009 Jeep Grand Cherokee Limited, 4.7 P, 4WD
Monitor Conditions
2009 Jeep Grand Cherokee Limited, 4.7 P, 4WDSECTION Monitor Conditions
- When Monitored:
Continuously with the ignition on, engine running, transmission in gear, and Input Speed Sensor 1 (N2) greater than 0 RPM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.