Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Theory Of Operation
The family of B2100 Diagnostic Trouble Codes (DTCs) typically describes ignition performance related faults. These are often caused by a contradiction of switch status information. For example, if an Electronic Control Unit (ECU) receives a bussed message indicating ignition switch position but the state of a hardwired ignition circuit indicates another switch position a B2100 series DTC would likely result.
These DTCs can be caused by a number of conditions including:
- loose connections
- missing or blown fuses
- faulty component
- vehicle no start or long crank time
Verify the proper operation of the starting system and verify that this DTC is active before proceeding with the diagnostic test.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.