Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009GRAND CHEROKEE 2WD V8-4.7LREPAIR AND DIAGNOSISLIGHTING AND HORNSTRAILER LIGHTING MODULESERVICE AND REPAIRTRAILER TOW MODULE - REMOVAL
2009 Jeep Grand Cherokee 2WD V8-4.7L
Trailer Tow Module - Removal
2009 Jeep Grand Cherokee 2WD V8-4.7LSECTION Trailer Tow Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear seat cushion from the rear floor panel. Seat Cushion Cover - Removal.
3. Disconnect the four body wire harness connectors from the connector receptacles (4) on the back of the Trailer Module (TM) (1).
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the latch features (5) on each side of the mounting plate (2) away from the mounting tabs of the module far enough to disengage the module.
5. Remove the module from the mounting plate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.