SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009GRAND CHEROKEE 2WD V8-4.7L FLEX FUELREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL LAMPSERVICE AND REPAIRTAIL STOP TURN LAMP - INSTALLATION
2009 Jeep Grand Cherokee 2WD V8-4.7L Flex Fuel

Tail Stop Turn Lamp - Installation

2009 Jeep Grand Cherokee 2WD V8-4.7L Flex FuelSECTION Tail Stop Turn Lamp - Installation





LAMP - DOMESTIC





1. Position the rear lamp unit to the lamp opening of the quarter outer panel.
2. Reconnect the two wire harness connectors to the two bulb sockets on the back of the lamp housing.
3. Engage the retainer on the wire harness for the lamp into the tab on the back of the lamp housing.
4. Check to be certain that the two grommets (5) are in good condition and properly installed in the quarter outer panel (1).
5. Align the two ball studs (4) on the outboard side of the lamp housing (3) with the two grommets in the quarter outer panel.
6. Using hand pressure, push firmly and evenly on the outboard side of the lamp until both ball studs snap into the grommets.
7. Install the two plastic push-pin fasteners (2) that secure the rear lamp unit to the side jamb of the liftgate opening.
8. Reconnect the battery negative cable.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.