SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009GRAND CHEROKEE 2WD V6-3.7LREPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LAMPSERVICE AND REPAIRTAIL STOP TURN LAMP - REMOVAL
2009 Jeep Grand Cherokee 2WD V6-3.7L

Tail Stop Turn Lamp - Removal

2009 Jeep Grand Cherokee 2WD V6-3.7LSECTION Tail Stop Turn Lamp - Removal





LAMP - DOMESTIC





1. Disconnect and isolate the battery negative cable.
2. Open the liftgate to access and remove the two plastic push-pin fasteners (2) that secure the rear lamp unit (3) to the side jamb of the liftgate opening.
3. Pull the outboard side of the rear lamp unit rearward far enough to unsnap the two ball studs (4) on the outboard side of the lamp housing from the two round grommets (5) in the quarter outer panel (1).
4. Pull the lamp away from the vehicle far enough to access and disengage the retainer on the wire harness for the lamp from the tab on the back of the lamp housing.
5. Disconnect the two wire harness connectors from the two bulb sockets on the back of the lamp housing.
6. Remove the lamp from the lamp opening of the quarter outer panel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.