Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMPASS SPORT, 2.4 B, EDG, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCONTROL UNITS
2009 Jeep Compass Sport, 2.4 B, EDG, Standard
Control Units
2009 Jeep Compass Sport, 2.4 B, EDG, StandardSECTION Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Anti-Lock Brakes Module | Left rear engine compartment. See Figure. |
| Compass Module | Center stack. See Figure. |
| Fuel Pump Module | On fuel tank. See Figure. |
| Fuel Pump Module (FWD) | On fuel tank. See Figure. |
| Hands Free Module | Right side of dash. See Figure. |
| Heated Seats Module | Under driver seat. See Figure. |
| Intrusion Transceiver Module | Center of dash. See Figure. |
| Inverter Module | Center of dash. See Figure. |
| Occupant Restraint Controller Module | Under center of dash. See Figure. |
| Powertrain Control Module | Left rear engine compartment. See Figure. |
| Radiator Cooling Fan Module | Front of engine compartment. See Figure. |
| Sentry Key Remote Entry/WCM Module | Steering column. See Figure. |
| Steering Control Module | Steering column. See Figure. |
| Transmission Control Module | Under left side of dash. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.