Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMPASS SPORT, 2.4 B, ED3, FWD, AUTOMATIC CVTREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANS(TRANSMISSION CONTROL MODULE (TCM) - ELECTRICAL DIAGNOSTICS)DTC TROUBLESHOOTINGP0721-OUTPUT SPEED SENSOR CIRCUIT PERFORMANCESET CONDITIONS
2009 Jeep Compass Sport, 2.4 B, ED3, FWD, Automatic CVT
Set Conditions
2009 Jeep Compass Sport, 2.4 B, ED3, FWD, Automatic CVTSECTION Set Conditions
- Set Condition:
All the below conditions must be present for the period of 5 seconds for the DTC to set:
- Engine speed minus the primary speed is less than 1000 RPM.
- Secondary speed multiplied by the estimated ratio, minus the Primary speed is greater than 1000 RPM.
- Vehicle speed minus the Vehicle speed calculated using the Secondary speed, is greater than or equal to 20 Km/h (12.5 mph)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.