Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMPASS SPORT, 2.4 B, ED3, AWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 ((TRANSMISSION CONTROL MODULE (TCM) - ELECTRICAL DIAGNOSTICS))DTC TROUBLESHOOTINGP0602-CONTROL MODULE PROGRAMING ERROR/NOT PROGRAMMEDPOSSIBLE CAUSES
2009 Jeep Compass Sport, 2.4 B, ED3, AWD, Standard
Possible Causes
2009 Jeep Compass Sport, 2.4 B, ED3, AWD, StandardSECTION Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| CAN BUS DTCS PRESENT |
| TOTALLY INTEGRATED CONTROL MODULE (TIPM) NOT PROGRAMED |
| TRANSMISSION CONTROL MODULE (TCM) |
Always perform the CVT Pre-Diagnostic Troubleshooting procedure before proceeding. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.