Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMPASS LIMITED, EDG, AUTOMATIC CVTREPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEMIGNITION CONTROL (SERVICE INFORMATION)COIL, IGNITIONREMOVALREMOVAL
2009 Jeep Compass Limited, EDG, Automatic CVT
COIL, Ignition: Removal: Removal
2009 Jeep Compass Limited, EDG, Automatic CVTSECTION Removal
The electronic ignition coil attaches directly to the valve cover.
- Remove the negative battery cable.
- Disconnect electrical connector from ignition coil.
- Remove ignition coil mounting bolts.
- Remove ignition coil.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.