Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTRADIO, STEREO, AND COMPACT DISCRADIO/STEREOSERVICE AND REPAIRREMOVAL AND REPLACEMENTRADIO - INSTALLATION
2009 Jeep Compass 4WD L4-2.4L
Radio - Installation
2009 Jeep Compass 4WD L4-2.4LSECTION Radio - Installation
INSTALLATION
1. Connect the wire harness connectors and antenna cable to radio.
2. Insert radio into instrument panel.
3. Install mounting fasteners. Tighten to 2 Nm (20 in. lbs.).
4. Install instrument panel center bezel. Instrument Panel Bezel - Installation.
5. Connect battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.