Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER SPORT, 3.7 K, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESVIDEO ENTERTAINMENT SYSTEM (VES3) - ELECTRICAL DIAGNOSTICS
2009 Jeep Commander Sport, 3.7 K, RWD
Video Entertainment System (VES3) - Electrical Diagnostics
2009 Jeep Commander Sport, 3.7 K, RWDSECTION Video Entertainment System (VES3) - Electrical Diagnostics
- Diagnostic Code Index
- DTC Troubleshooting
- B142B-VES Unit High Temperature
- B14CE-VES Brightness Up Input Button Stuck
- B14CF-VES Brightness Down Input Switch Stuck
- B210A-System Voltage Low
- B210B-System Voltage High
- B210D-Battery Voltage Low
- B210E-Battery Voltage High
- B21A1-Ecu Reset/Recovery Occurred
- B222B-Vehicle Entertainment System Internal
- B222C-Vehicle Configuration Not Programmed
- U0019-Can B Bus
- U0020-Can B Bus Off Performance
- U0010 Can Interior Bus
- U0141-Lost Communication With Front Control Module
- U0155-Lost Communication With Cluster/CCN
- U0168-Lost Communication With Vehicle Security Control Module (Win)
- U0184-Lost Communication With Radio
- U0195-Lost Communication With SDAR
- U0197-Lost Communication With Hands Free Phone Module
- U0199-Lost Communication With Driver Door Module
- U0200-Lost Communication With Passenger Door Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.