Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER OVERLAND, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEMIGNITION CONTROL (SERVICE INFORMATION)COIL, IGNITIONREMOVAL5.7L
2009 Jeep Commander Overland, RWD
COIL, Ignition: Removal: 5.7L
2009 Jeep Commander Overland, RWDSECTION 5.7L
- Disconnect the electrical connector (1) from coil (3).
- Clean area at base of coil with compressed air before removal.
- Remove two mounting bolts (2) (note that mounting bolts are retained to coil).
- Carefully pull up coil (1) from valve cover.
- Remove coil (1) from vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.