Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Park Assist Module - Installation
2009 Jeep Commander 4WD V8-5.7LSECTION Park Assist Module - Installation
INSTALLATION
1. Position the park assist module (1) into the cavity on the left outboard end of the intermediate step assembly (3) and insert the two mounting tabs on the rear side of the module into the slots in the back of the cavity.
2. Slide the module toward the rear of the intermediate step cavity, then push downward on the front of the module until the two latch features integral to the cavity are fully engaged over the mounting tabs on the front (connector) side of the module.
3. Reconnect the underbody wire harness connector (2) to the module connector receptacle. Vehicles with the front park assist option will have a second connection to the module at this location, which must also be reconnected.
4. Reinstall the carpeted cover panel over the cavity on the left outboard end of the intermediate step assembly.
5. Restore the left outboard second row seat assembly to its normal seating position.
6. Reconnect the battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.