Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 4WD V8-5.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOXYGEN SENSORSERVICE AND REPAIRREMOVAL
2009 Jeep Commander 4WD V8-5.7L
Removal
2009 Jeep Commander 4WD V8-5.7LSECTION Removal
REMOVAL
Refer to graphic for typical O2S (oxygen sensor) locations if equipped with four oxygen sensors.
Refer to graphic for typical O2S (oxygen sensor) locations if equipped with two oxygen sensors.
CAUTION: Never apply any type of grease to the oxygen sensor electrical connector, or attempt any soldering of the sensor wiring harness.
WARNING: The exhaust manifold, exhaust pipes and catalytic converter become very hot during engine operation. Allow the engine to cool before removing the oxygen sensor.
1. Raise and support the vehicle.
2. Disconnect the electrical connector from O2S sensor.
3. If equipped with four oxygen sensors and removing the right-upstream O2S (2/1) sensor, support the transmission with a safety stand or jack and remove the bolts attaching the crossmember to frame and slightly lower the transmission to gain access to the O2S sensor electrical connector, disconnect the connector.
CAUTION: When disconnecting the sensor electrical connector, do not pull directly on the wire going into sensor.
4. Remove O2S sensor with an oxygen sensor removal and installation tool.
5. Clean threads in exhaust pipe using appropriate tap.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.